It’s a smart decision to buy a Wavlink WiFi range extender. However, your patience will be tested by online sites that take an eternity to load. When you need to get work done quickly, slow WiFi connectivity may be very annoying. The majority of us believe that resetting the Wavlink WiFi repeater to factory settings would resolve the problem. But, before that, there are a few hacks that need to be implemented to bid farewell to the problem. Perhaps, your router and internet connection is not functioning properly.
Fixed: Wavlink WiFi Repeater Slow Speeds
Some potential causes of slow speeds and dropped connections on your Wavlink WiFi repeater are discussed below. Let’s make an effort to wipe them out.
Fix the Extender-Router Distance
The first possible cause is the physical separation between your existing device and the Wavlink WiFi repeater. The speed and signal loss of the Wavlink wireless range extender also depends on devices’ (WiFi router and Wavlink repeater) distance. Consequently, wireless internet speeds are diminished. Bringing your host router close to your Wavlink may improve efficiency and performance.
But, the distance needs to be appropriate. We never want you to face any issue just because the WiFi signals of your Wavlink extender and the router have been involved in a clash. The Wavlink extender wired backhaul setup is also available in case using a wireless source is not your cup of tea.
Physical Impedances
Don’t let your Wavlink wireless range extender get suffocated. Do not keep behind any kind of closed door or inside a cabinet. They serve as signal breakers, preventing WiFi from functioning. The more barriers there are, the weaker the signal. This is because certain building materials can absorb the signals while others reflect them.
Congested WiFi Channels
Congestion on wireless networks is more likely in highly crowded areas, such as apartment buildings. Most networking devices have preset channel and frequency preferences. Therefore, your signal competes with that of every other device in the area. Changing the channel on your Wavlink extender is the best approach to get the signal to stop competing. If you visit wifi wavlink com ap setup, you’ll be taken to the Wavlink WiFi repeater control panel after inputting the default credentials. Modify the 2.4 GHz channels to 1, 6, and 11. Also, check to see if nobody in the area is logging into your WiFi extender.
Interference from Gadgets
Gadgets such as cell phones, baby monitors, and microwave ovens can also impact the extender’s signals. Devices such as cordless phones, microwaves, and wireless security cameras that use the same radio frequency as your Wavlink extender may significantly reduce its throughput. You may notice a decrease in WiFi speed if you have many wireless devices operating on the same frequency, i.e. 2.4GHz.
Quick Tip: Take note that your broadband package determines the maximum speed at which you may access the internet. Just before taking the last step, you should contact your Internet service provider about the sudden slowdowns.
RESET is the Final Resort
If you have already done everything listed above to solve the poor speeds and drop connection problem on your Wavlink WiFi repeater, but nothing has worked, continue reading. The next step is to return your Wavlink to its original configuration.
- To factory reset your Wavlink wireless device, all you need is a paper clip.
- Install your Wavlink repeater by connecting it to a power source.
- Hold off until the lights get solid green.
- A reset hole needs to be found at the rear of your extender.
- To reset it, insert the paperclip.
You have completed the reset procedure for the Wavlink range extender. Attempt a new configuration now. Just in case you want your Wavlink router to get back to its default settings, the procedure will remain the same. However, you can reconfigure your extender using the default extender password whereas the default Wavlink router password can be used for the router installation process.
