Refilling a vape is pretty easier than you think; regardless you have recently switched to vaping from smoking, still you can be able to do it. Whether a vape has been just introduced to you or you’re using disposable vapes like Elf bar 1500 before, it’s convenient in both situations.

Before starting to chase the guidelines on how to fill a vape tank, you must take a few precautionary measures. There are two things you need to consider before taking any step, number one is knowing your vape tank, including what sort of tank you have and how it opens and closes. Number two is removing your tank from the battery. It’s very critical that you detach the battery for the sake of your vape’s life. Otherwise, your battery could be easily damaged.

There are a couple of steps to guide you on how to fill a vape with E-liquid.

Step No 1:  Disassemble the Vape Tank

The first thing you need to do is open the tank and prepare it to fill.

●    Detach the Tank:

The most initial step is opening the vape tank to make it ready to get refilled. Start disassembling the tank parts from disconnecting the airflow base and the coil.

●    Open the Refill Hatch:

In case there’s a fill latch or top cap on your vape, place it between the drip tip and tank. Wrench it open with little force, but don’t assert too much pressure to make it lose and free.

●    Remove the Top/Bottom of the Vape:

Flip the tank upside down to check whether your tank has an opening from the top or bottom. Your vape may be created to fill with the top removed; if so twist off the drip tip at top of it and find where you can load the tank. Whereas if your tank has access from the bottom to it, then detach both the airflow base and the coil until you can reach the opening point.

Step No 2: Prepare the Tank for Refilling Procedure:

●    Pour out Old E-liquid:

If there’s still E-liquid in the tank, pour it out in order to keep your tank filled with only fresh E-liquid. But if the leftover is fresh or you are satisfied with mixing the new with old, you can keep it.

●    Switch Flavour (Optional):

There are various flavours in E-liquids, and all have different smells and tastes. Usually, a single flavour is taken at a time but many vapours have a taste for mixed flavours also. So It’s up to you whether you choose one or do mixing. If you don’t want to mix flavours then you must follow the below procedure.

●    Clean the Tank:

With the use of water and little soap, wipe down the tank and its pieces then swill and dry out the tank. You can use a cloth to dry it or just keep it open in the air for a minute or two.

●    Change the Coil and Install a new one:

Replacing the previous coil is very important if you’re switching flavours because if you don’t change the coil then you will have a taste of mixed flavours. The best way to avoid mixing flavours and enjoy taste is to assign a coil to a particular flavour.

Step No 3: Prepare the Coil/Wick:

Next is the preparation of the coil to use. Take the dropper and fill it with E-liquid from the E-liquid bottle. Hold the coil horizontally between your thumb and index finger. Then put a single drop onto each cotton hole in the coil to get it suffused with the liquid over time. This is known as “Coil Preparation and Preservation of The Life of The Coil”.Unlike the disposable vapes, you own this.

Step No 4: Fill the Tank With the E-liquid:

Now fill the tank with the new E-liquid. Be very careful while filing in order to keep it smooth. Try to pour the flavour and make it flow down by the side of the tank’s glass. Make sure not to fill in the centre of the tube. If you do that it will come in your mouth without being processed, into liquid form.

Step No 5: Reassemble Your Vape Parts:

Finally, gather your vape parts and rejoin all pieces, put them where they were before. Wrench the parts, starting from the coil/wick followed by joining the connector, then the E-liquid tank and mouthpiece. Ensure all the parts are connected properly, especially examine the tank and make sure it doesn’t leave any leak ends.

Step No 6: Wait a Couple of Minutes Before Start Vaping:

At last, after following all the aforementioned steps, leave the vape free. Give the vaporizer 2-3 minutes so the coil can soak up the E-liquid properly. Also, you can scrutinize if the vape has any misplacement or loose ends.

Step No 7: Enjoy your Vape!

Now your vape is ready to use. Indulge yourself with the freshly filled vaporizer and take a chill pill.

Bottom line:

This blog contains the method of refilling a vape tank. If you find it hard or inconvenient to refill your vape tank, you can simply go for a disposable vape like Elux legend 3500 puffs. Basically, these vapes need zero maintenance. All you need to do is to buy a disposable vape device and start enjoying puffs without any refilling procedure and throw it in the bin when the e-liquid gets finished.